Centrifugal pump selection software helps engineering and sales teams match a required flow and head to published pump curves. The most useful output is a documented selection that another engineer can review: the duty point, the curve conditions, the alternatives considered and any assumptions still awaiting confirmation.
1. Record the duty point and its assumptions
Start with the required flow and total head. Record the liquid, temperature, and expected minimum and maximum operating conditions. If a customer gives a pressure requirement, confirm the measurement points and fluid density before comparing it with a head curve. Keep the original units alongside any converted values so colleagues can reproduce the selection.
For example, an enquiry might specify 50 m³/h at 32 m of head. That pair gives you a duty point to screen against the catalogue. It does not establish the full system curve or account for changes in operating conditions. If the flow varies, collect the other expected duty points before narrowing the shortlist.
2. Compare curves at the same operating conditions
Check that each candidate curve applies to the intended speed, impeller diameter and fluid conditions. When you have a system curve, its intersection with the pump head curve indicates the expected operating point for that setup. Where the system curve is unavailable, record that the shortlist was screened against the stated duty point and flag the missing information for review.
- Head and flow: Check whether the model covers the stated duty point and expected operating range.
- Efficiency: Compare efficiencies at the expected operating points and check the manufacturer’s recommended operating region.
- Power: Review the power curve across the anticipated operating range and verify the motor selection with the manufacturer.
- Suction conditions: Compare the system’s available net positive suction head (NPSHa) with the pump’s published requirement and confirm the margin appropriate for the application.
The Hydraulic Institute’s pump FAQs explain the best efficiency point (BEP) and preferred operating region. Use the specific manufacturer’s curve and guidance when assessing a model.
3. Keep a selection record engineers and sales teams can share
Save the model, speed, impeller diameter, duty point, curve revision and any exclusions with the quotation. If the customer changes a requirement, reopen the selection and record the updated basis. For teams supporting different markets, include the original SI or US customary units and state the test or catalogue conditions clearly.
Velotech Solutions’ pump selection software supports duty-based search, performance curve evaluation and technical datasheets. Bring one representative enquiry to your software evaluation and compare its output with the selection your team would normally produce. The pump selection software demo checklist explains what to prepare.
4. Carry the selection basis into testing
Share the selected curve and agreed acceptance criteria with the test team so everyone can refer to the same duty point. If you also manage a test bench, see how pump testing software and PLC automation fit into the workflow.
Frequently asked questions
Is a duty point enough to choose a centrifugal pump?
Flow and head are enough for an initial search. A final review also considers fluid and suction conditions, the operating range and the manufacturer’s guidance for the specific model.
How should we evaluate centrifugal pump selection software?
Use a real enquiry with known requirements. Check whether the software can retrieve suitable models, show comparable curves, and produce a datasheet with enough detail to review the result.
Discuss your pump selection workflow
Contact Velotech Solutions with a sample duty point, the pump families you work with and the technical documents your sales and engineering teams need.